Normal Operation - Takagi T-M50 Installation Manual And Owner's Manual

NORMAL OPERATION

• Flow rate to activate the 910 (T-M50)
• Flow rate to keep the 910 (T-M50) running : 0.4 gallon per minute
1. Open a hot water tap.* 2. Mix cold water with the hot to get
WITH REMOTE CONTROLLER INSTALLED: 9007603005 (TM-RE30) (Optional)
1. Press the power ON/OFF button.
Increasing temperature from 120 °F (50 °C) to 140 °F (60 °C)
•
Press the "HOT" button to set 120 °F (50 °C).
•
Press and hold the "INFO" button and the "HOT" button for at least 3 seconds. The remote will emit
a beep and change to 125 °F (52 °C).
•
Press the "HOT" button to set up to 140 °F (60 °C).
Increasing temperature above 140 °F (60 °C)
•
Press the "HOT" button to set 140 °F (60 °C).
•
Press and hold the "INFO" button and the "HOT" button for at least 3 seconds. The remote will emit
a beep and change to 145 °F (63 °C).
•
Press the "HOT" button to set up to 175 °F (80 °C) or 185 °F (85 °C).
Temperatures available under the Default Mode
100 105 110 115
Temperatures available under the High Temperature Mode* (Refer to p. 31 for details.)
110 115 120 125
3. Open a hot water tap.
Mix cold water with the hot if you need.
Hot Water temperatures over 125 °F (52 ºC) can cause severe burns instantly or death from
scalding.
The outlet hot water temperature of the water heater is factory set at 120 °F (50 ºC).
•
• Feel the water temperature before bathing or showering.
WITHOUT REMOTE CONTROLLER
the suitable temperature water.
When ON,
green LED is lit.
The temperature and the
time will be displayed on
the remote controller.
120 125 130 135
130 135 140 145
Lam p i s O N
Lamp is ON
WARNING
: 0.5 gallon per minute
2. Press the HOT/COLD button to set
the water temperature up to 120 °F (50 °C).
140 145 150 155
150 155 160 165
4. Close the hot water tap.
- 30 -
3. Close the hot water tap.
(EX: 110°Ｆ)
(Unit: °F)
160 165 170
(Unit: °F)
170 175 180
Lam p i s O FF
Lamp is OFF
175
185