Obtain A Power Cord; Turn On Video Monitor And Server - Intel AC450NX Quick Start Manual

Obtain a power cord

WARNING
Do not attempt to modify or use an AC power cord that is not the exact
type required.
Because power cords are not supplied for the server, you must obtain a power cord that meets the
following criteria:
•
The cord must be rated for the available AC voltage and have a current rating that is at least
125% of the current rating of the server (see the label on your server).
•
The connector that plugs into the wall outlet must be a grounding-type plug designed for use in
your region. It must have certification marks showing certification by an agency acceptable in
your region.
•
The connector that plugs into the AC receptacle on the server must be an IEC 320 C19 type
outlet.
• The cord must be less than 4.5 meters (14.76 feet) long, and it must be flexible <HAR>
(harmonized) or VDE certified cordage to comply with the server safety certifications.

Turn on video monitor and server

WARNING
The push-button on/off power switch on the front panel of the server
does not turn off the AC power. To remove AC power from the server,
you must unplug the power cord from the wall outlet.
1. Make sure all external devices, such as a video monitor, printer, keyboard, and mouse
(optional) have been connected.
2. Remove drive protection cards (if present) from the removable media drives.
3. Turn on your video monitor and printer.
4. Plug the female end of the power cord into the server input receptacle on the back of the
chassis.
5. Plug the power cord into a properly grounded power outlet.
6. If the server does not come on when you plug the power cords into the power outlets, press the
power switch on the front panel.
7. Verify that the power-on light on the front panel is lit. After a few seconds the power-on self
test (POST) begins. See "Power-on self test" on page 11.
AC450NX Rack Server System 9