Symbologies; Wand Emulation - PSC QuickScan 6000 Programming Manual

Symbology selection (bar code type) determines which symbologies the
scanner will decode. The chart below shows the symbologies that are
supported by each interface. Once you have identified the symbologies
you wish to enable, turn to the following pages, enable those symbolo-
gies and set the data format options (e.g. check digit, start/stop characters)
required by your host system for each symbology type. You must enable
the symbology format options settings that are compatible with your host
system.
The factory settings for each interface were chosen to meet the standard
industry requirements and in most cases you will not need to change the
symbology format settings. If you are unsure of your system require-
ments, test the scanner using the factory settings before making any
changes.
INTERFACE TYPE
IBM Port 5B
IBM Port 9B
IBM Port E
NCA OCIA (8 bit)
NCA OCIA (9 bit)
PSC OCIA
SNI OCIA

Wand Emulation

RS-232
Keyboard Wedge
KEY
QuickScan 6000 and QuickScan 6000 Plus
QuickScan 6000 Plus
{
The symbology can be enabled through configuration item; however,
labels will not be decoded or transmitted by the interface.
46

Symbologies

QuickScan 6000/6000 Plus Programming Guide