PSC QuickScan 6000 Programming Manual page 40

Setting A Single Character Prefix or Suffix
To set one ASCII character as a prefix or suffix, follow steps one through
four on the previous two pages (select prefix or suffix), then...
1. Scan the two digit Hex Code for that character.
(e.g. 03, 8F, ...FF)
If you make a mistake, or lose your place while setting this option,
scan the END label to exit Programming Mode. The scanner will
sound an error tone (six rapid beeps) to indicate that programming
was incomplete, and the setting will remain as it was before
entering Programming Mode.
2. Scan the ONE CHARACTER ONLY label on the following
page.
3. Scan the END label.
You have set a single character prefix or suffix.
Setting Prefix and/or Suffix Characters
You must scan the SET label and either the SET PREFIX or SET
SUFFIX label before using the labels on this page.
0 ------------------------------------
1 ------------------------------------
2 ------------------------------------
3 ------------------------------------
4 ------------------------------------
5 ------------------------------------
36
NOTE
NOTE
QuickScan 6000/6000 Plus Programming Guide