Where To Go From Here - PSC QuickScan 6000 Programming Manual

Where To Go From Here

Programming is easy and straightforward if you follow these steps:
1. If you are changing interfaces, first connect the scanner to the
new host using the new interface cable. Scan the interface
enable bar code label
2. Scan any feature labels that are unique to the interface you
are currently programming. These interface specific program-
ming labels immediately follow each interface selection label.
3. Turn to the Symbology section if you are going to change
any bar code symbologies or modify any symbology related
features.
4. Turn to the General Features section of this guide if you wish
to change or modify any of the scanner's other features.
Once the necessary changes have been made, and you have scanned the
END label, you are ready to scan.
1 This step is not necessary for QuickScan 6000 Plus scanners, unless you require a specific
interface sub-type such as SNI OCIA or IBM sub-type 4682/92 Port E. Interface software is
automatically selected when the QuickScan 6000 Plus hardware connection (via a new
interface cable) is made.
8
1
.
QuickScan 6000/6000 Plus Programming Guide