Attaching The Sensor To The Bracket; Vertical Adjustment And Cable Routing - Furuno GP-1650WF Installation & Maintenance

Attaching the sensor to the bracket

1. If the retaining cover near the top of the bracket is closed, open it by depressing the
latch and rotating the cover downward.
2. Insert the sensor's pivot arms into the slots near the top of the bracket.
3. Maintain pressure until the pivot arms click into place.
4. Rotate the sensor downward until the bottom snaps into the bracket.
5. Close the retaining cover to prevent the accidental release of the sensor when the boat
is underway.
Hull projection 3 mm (1/8")

Vertical adjustment and cable routing

Step 1
Latch
Pivot
arm (2)
Retaining
cover
Step 3
Attaching the sensor to the bracket
Cable cover
Cable
clamp
50 mm (2")
Step 2
Slot (2)
Step 4
1. INSTALLATION
1-17