Wiring The Cable Assembly; Attaching Chassis Assembly - Furuno GP-1650WF Installation & Maintenance

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650WF)
12. Connect the cable assy. S.FL2-2LP0.7-D-WHT (121) of J3 to J2 of the GN-8091.
13. Pass the mini pin coaxial cable of J1 on the GR-7000A through the mini plug on the
ANLG Board and connect it to J8 on the ANLG Board.
Heat sink
Connect cable assy.
J1 of GN-8091 to J106
of MAIN board.
to J8 of
ANLG board
to J106 of
MAIN board
to J107 of
MAIN board
14. Mount the ANLG board on the heat sink.
15. Mount chassis assembly on the panel assembly. Connect 8P connector and 6P
connector to Main board as shown in the figure below.
A
View
4-6
GR-7000A
Clamp
J1
GR-7000A
GN-8091
J1
J3
J2
Connect PH6P-W-L240 between J2 of
GR-7000A and J107 of MAIN board.

Wiring the Cable assembly

A
PH8P
J106
PH6P
J107
Panel assembly

Attaching chassis assembly

Mini pin coxial cable
GN-8091
Cable tie
Connect mini pin coaxial cable
between J1 of GR-7000A and J8 of
ANLG board.
J2
Connect cable assy.
J3 of GR-7000A to
J2 of GN-8091.
Chassis assembly
Connector