Installation Of Beacon Receiver; Dismounting Chassis Assembly; Cutting Cable Ties - Furuno GP-1650WF Installation & Maintenance

4. INCORPORATION OF DGPS BEACON RECEIVER KIT (for GP-1650WF)

Installation of beacon receiver

Procedure
1. Disconnect 8P connector as shown in the figure below.
A View
2. Dismount chassis assembly from panel assembly by disconnecting connector shown in
the figure above.
3. Cut the cable ties as shown in the figure below.
PH8P
J106

Dismounting chassis assembly

Cut cable tie.
ANLG board
J8
Cut cable tie.

Cutting cable ties

Chassis assembly
A
Panel assembly
GN-8901
Connector
4-3