Selecting The Playback Port To Be Controlled; Selecting The Video And Audio Signals To Be Monitored; Selecting The Displayed Time Data - Sony MAV-777 Operation Manual

4-2-2 Selecting the Playback Port to
be Controlled
Because the MAV-777 can handle up to three playback
ports, when making the various settings concerning
playback it is first necessary to specify which playback
port is the target of the setting. (Settings must be made
individually for each port.)
To select a playback port, press the PORT SELECT button
that corresponds to that port so that the button is lit.
Note
The PORT SELECT button that needs to be pressed in
order to select a playback port depends on the port
configuration selected on the menu, as described in the
table below.
PORT
SELECT Application Installed boards
button
P3/P2 Selecting the BKMA-720 and 730 2 input/2 output
P2 port
BKMA-730 × 2
P2/P3 Selecting the BKMA-730 × 2
P3 port
4-2-3 Selecting the Video and Audio
Signals to be Monitored
This section describes how to select the video and audio
signals to be monitored.
Note
The video and audio signals in the monitor output are
those of the currently selected port.
Selecting the video signals to be
monitored
The video signal of the currently selected port is output
from the HD SDI (SUPER), SD SDI (SUPER), and
ANALOG COMPOSITE (SUPER) connectors.
Character information is superimposed on the outputs
from these connectors.
For details of settings relating to the superimposed character
information, see Section 3-4-1, "Basic Menu Settings" (page 3-12).
Selecting the audio signals to be
monitored
Using the AUDIO INPUT/MONITOR SELECT buttons,
switch the audio signals output from the PHONES jack,
SD SDI (SUPER), and MONITOR OUTPUT L/R
connectors, as follows.
1
Press the MONITOR SELECT button, turning it on.
The AUDIO INPUT/MONITOR SELECT buttons
which are lit show the current monitoring selection.
2
Press the corresponding buttons, turning them on, to
select from channels 1 to 4 for the L and R monitoring
channels (a channel can be assigned to both L and R).
Notes
• The monitored audio signal uses the same port as the
video signal.
• Audio signals output from the SD SDI (SUPER)
connector are as follows:
CH1: Audio monitor output. Same as the Lch signal.
CH2: Audio monitor output. Same as the Rch signal.
CH3: No output.
CH4: No output.
• Audio is not output from the HD SDI (SUPER)
Port
connector.
configuration
To adjust the volume of the audio output from the
PHONES jack
1 input/3 output
Turn the PHONES control.
1 input/3 output
4-2-4 Selecting the Displayed Time
You can select the time data displayed in the time data
indicator from the following:
• Time data
• User bits
To display time data
To display time data, use the following procedure.
1
With the PORT SELECT buttons, select the playback
port to which the setting applies.
2
Press the TC/UB button, turning it off.
3
Press the TIMER SEL button, to select the type of
timecode you want to display. Each time you press the
TIMER SEL button cycles through the following
indications in the display panel for the playback port
for which the setting is currently being made: LTC t
VITC t TM1 t TM2 t LTC.
To display user bits
To display user bits, use the following procedure.
However, when time data is TM1 or TM2, the user bit does
not appear.
1
With the PORT SELECT buttons, select the playback
port to which the setting applies.
Data
4-2 Preparations for Playback
4-5 (E)