Table of Contents
Advertisement
Refer to the DTR-3000 Operating Manual for further details.
The input signal can be verified at the output terminal by pressing
the REC key by itself.
Re-recording from the beginning of the
recording area
Recording cannot be restarted randomly within previously
recorded material: it is always resumed from the point
where it was last stopped. To re-record from the beginning
of the recording area, perform the following procedure:
1
Assuming it is okay to delete all material on this unit,
execute ALL ERASE (menu 099) on the basic menu,
and reboot the unit.
* If you don't want to delete all material, change this
unit to the Panel mode, delete the "LIVE1" (and
"LIVE2") material, the change back to the
DTR+Panel (or DTR+DTR) mode. However, if you
want to retain previously recorded material, rename
it to something other than "LIVE1" or "LIVE2."
2
Follow the above steps for recording from the DTR-
3000 to re-record.
Recording starts at the beginning of the recording
area.
Playback from the DTR-3000
1
Press the PLAY key on the DTR-3000.
• Playback starts at the playback port of this unit that
is connected to the controlling DTR-3000.
• You can adjust the playback speed using the DTR-
3000 Jog control.
Refer to the DTR-3000 Operating Manual for further details.
Changing the playback material
The material for playback with DTR-3000 operations can
be changed from the Control Panel.
Use the same procedure as for the Panel mode to change
the material at the playback port (P1 or P2) being used for
DTR-3000 operation.
For details on the procedure, refer to Section 5-2-2, "Playback
Operation" (page 5-1).
Editing from the control panel
In the DTR+Panel mode, the R2, P2, P3 Port can be used
from the control panel, so the materials being spliced/
recorded with operation from the DTR-3000 can be edited
using the existing materials in the MAV-777.
Even if the source material being loop recorded is
overwritten by the Audio Channel mode loop recording
with the Video/Audio mode, the referenced portion is not
deleted.
For details about the control panel, refer to Volume II of this
operation manual.
5-4 (E)
5-3 Basic Operations with DTR+Panel and DTR+DTR Modes
Saving part of the material during loop
recording
During loop recording, if material is recorded beyond the
time set as the LIVE DURATION, previously recorded
material will be overwritten. If necessary, any part of the
recorded material can be saved as follows to prevent it
from being overwritten.
1
In GOOD SHOT PARAMETER (menu 030), change
the AUTO SAVE setting to "cut up with data" and
restart the set.
2
During recording, cue up to the part which you wish
to save. The interval saved is the one set in SAVE
DURATION on GOOD SHOT PARAMETER (menu
030), when the save duration starts at the cue point
and the TRIM SIZE is added to both ends of the
section.
Notes
• When disk space is not sufficient, recording stops
shortly after performing this operation.
Before performing partial save, make sure disk space is
sufficient, then set LIVE DURATION (menu 034).
• Partial save is also possible when LOOP REC on LIVE
DURATION is OFF (menu 034).
Advertisement
Table of Contents
