Table of Contents
Advertisement
Item number Display indication
827
AUDIO OUTPUT PHASE P1
828
AUDIO OUTPUT PHASE P2
829
AUDIO OUTPUT PHASE P3
BI
880
INTERNAL AUDIO SIGNAL
GENERATOR R1
881
INTERNAL AUDIO SIGNAL
GENERATOR R2
882
INTERNAL AUDIO SIGNAL
BI
GENERATOR R2
886
RATE CONVERTER R1
887
RATE CONVERTER R2
888
RATE CONVERTER R3
BI
901
DOWN CONVERTER P1
902
DOWN CONVERTER P2
903
DOWN CONVERTER P3
904
DOWN CONVERTER R1
905
DOWN CONVERTER R2
906
DOWN CONVERTER R3
BI
SUB MENU
CONVERTER MODE
LETTER BOX
H CROP POSITION
CROSS COLOR
DETAIL GAIN
LIMITTER
CRISP THRESHOLD
LEVEL DEPEND THRESHOLD Adjusts image enhancement. Sets the brightness range of outline enhancement.
H DETAIL FREQ
H/V RATIO
GAMMA LEVEL
Expansion menu items (Continued)
Settings
Description
Sets the output timing of the audio playback signal (SDI, AES/EBU only). With 0x100
as the reference, as it becomes smaller, the output timing comes earlier, and as it
becomes larger, the output timing comes later.
0×000 ..
0×100
.. 0×1ff
Selects the device to generate the internal audio test signal.
off
: No audio test signal is generated.
silence
: Silent signal.
1 KHz sine : Generates a sine wave of 1KHz - 20dB FS.
1 KHz-9 dB : Generates a sine wave of 1KHz - 9dB FS.
When not off
For any selection other than "off", press the INPUT SELECT button on the front panel to
switch the button on, and then press and hold down the CH1 AUDIO INPUT button for 3
sec. or more to switch all of the digital audio input signals for all channels to the internal
audio SG.
Specifies whether an audio AES/EBU rate converter is used.
enable
: Uses a rate converter.
disable
: Does not use a rate converter.
Sets the operation mode of the down converter.
Selects the mode of the down converter.
EDGE-CROP
: Selects the edge crop mode.
LETTER BOX : Selects the letterbox mode.
SQUEEZE
: Selects the squeeze mode.
When LETTER BOX is selected in CONVERTER MODE, selects the aspect ratio.
16:9
14:9
13:9
When EDGECROP is selected in CONVERTER MODE, adjusts the horizontal position
of the cropped portion.
8 ..
80
.. F8
Adjusts the cross color.
0 ..
8
.. 15
Adjusts image enhancement. Adjusts the sharpness of outlines.
0 ..
20
.. 7F
Adjusts image enhancement. Sets the maximum
level of detail that is added to enhance the base
signal.
0 ..
20
.. 3F
Adjusts image enhancement. Sets a threshold of low amplitude signal enhancement.
0
.. F
0 ..
8
.. F
Adjusts image enhancement. Sets the center frequency for outline enhancement.
2.6MHz
3.4MHz
3.9MHz
4.6MHz
Adjusts image enhancement. Sets the horizontal to vertical aspect ratio for outline
enhancement.
0 ..
3
.. 7
Adjusts image enhancement. Adjusts the slope of the correction curve.
0 ..
80
.. 100
3-31 (E)
3-4 Setup
Advertisement
Table of Contents
