Table of Contents
Advertisement
Item number Display indication
013
PB/EE SELECT P1
014
PB/EE SELECT P2
015
PB/EE SELECT P3
BI
016
CHARACTER POSITION V
BI
SHIFT
019
SYSTEM OPERATE
CONFIGURATION
020
HD-SDI MONITOR
BI
SUPERIMPOSE
OFFSET
SUB MENU
SUPER ON/OFF
H-POSITION OFFSET
V-POSITION OFFSET
022
ERROR
BI
INFORMATION
SELECT
SUB MENU
ERROR/WARNING
NOT ENOUGH SPACE
027
– FAST REBOOT
I SUB MENU
EXECUTE
3-14 (E)
3-4 Setup
Basic menu items (Continued)
Settings
For the PANEL, DTR+PANEL, DTR+DTR and BVE modes, specifies when the PB port
enters the state indicated by SETUP MENU 108 AUTO EE SELECT, and whether it
should automatically correspond to the REC port.
PB
: Always output at the PB side.
PB/EE
: Switch to the REC side according to the SETUP MENU 108 status.
Note:
In the BVE mode, "PB/EE SELECT P2" item (menu 014) and "PB/EE
SELECT P3" (menu 015) are disabled.
The vertical position of text display of time codes output from the MONITOR OUT
terminal, SD SDI (SUPER) terminal, can be more minutely adjusted than is possible
with SETUP MENU 003.
0
.. 20
Select the application mode for this unit.
PANEL
: All ports are controlled only from the Control panel
DTR + PANEL : Controls R1 and P1 with the DTR-3000, controls R2 and P2 (or P2 and
P3) from the Control panel.
DTR + DTR
: The R1/P1 and R2/P2 pairs are controlled by two DTR-3000 units.
BVE
: R1 and P1 are controlled as an RP port by the editor.
Specifies details of superimposed text information (such as timecodes) output to the HD-
SDI (SUPER) MONITOR OUT connector. The display position of superimposed text
information is linked to that specified by SETUP MENU 002 and 003. This item
specifies an offset from this position.
Specifies the type of control used with superimposed text information such as timecodes.
Switch
: Switches the CHARACTER SW on and off.
Inhibit
: Does not output superimposed text information.
Specifies the offset from the horizontal position specified for superimposed text
information in SETUP MENU item 002.
0 ..
6
.. F
Specifies the offset from the vertical position specified for superimposed text
information in SETUP MENU item 003.
0 ..
5
.. F
Activate or deactivate various status information display output from the MONITOR
OUT connectors of the SDI (SUPER), HD-SDI (SUPER), or ANALOG COMPOSITE
(SUPER) connectors.
Note:
This setting item takes priority over the system setup panel CHARACTER
switch setting.
Specifies whether the ERROR/WARNING display is on or off.
on
off
Note:
Even if this is set to "on", the warning message "Ref. Missing" is not
displayed.
Specifies whether a warning message is displayed when there remains approximately
five minutes of recording time on the HDD.
on
off
Carry out a fast reboot of the system. This is faster than switching the system off and on
again, because the HDD power supply is not turned off.
Start
: Start reboot.
Advertisement
Table of Contents
