Assembling Advancer Arm; Disassembling Tps - TOHATSU TLDI 40 Service Manual

Assembling Advancer Arm

Assemble the following components.
Advancer arm
Throttle link rod
TPS link rod
Oil pump link rod
Bolt: type H635
Washers
Collar
Install the following components.
Throttle link ball joint cap
TPS link ball joint cap
Oil pump ball joint cap
Install ball joint and cap by hand using a pinching
motion.
Take care not to apply force to the TPS lever.

Disassembling TPS

Disassemble the following components.
q TPS assembly
w Screw: type 420 panhead at 3 locations
Washers
Collars
Remove the following component.
q TPS assembly
• Confirm whether the arm springs back in
the * direction
• Confirm that arm moves smoothly.
• Check the connectors for damage.
• Never loosen small screw e that s locked in
place using paint.
• Doing so will change the 0 point setting,
making it unusable.
Refer to chapter 5 when conducting electrical
inspections.
4-32
w
*
e q