TOHATSU TLDI 40 Service Manual page 158

Cause
Cooling water inlet is clogged.
9-1-1.
Faulty water pump.
9-1-2.
Faulty battery or 2 batteries connected in
9-1-3.
series.
9-1-4. Faulty rectifier regulator.
Faulty TPS, faulty wiring connections or
9-1-5.
severed line in harness.
Wiring connections for TPS connectors
9-1-6.
(TPS1, TPS2) are reversed.
Remote control cable unit incorrectly
9-2-1.
installed or fault in remote control box.
Cooling water inlet clogged.
10-1-1.
Faulty water pump.
10-1-2.
Faulty thermostat.
10-1-3.
Cooling water path clogged.
10-1-4.
Faulty battery.
10-1-5.
Faulty charging coil.
10-1-6.
Faulty wiring to charging coil.
10-1-7.
Faulty battery cables or connectors.
10-1-8.
Faulty rectifier regulator.
10-1-9.
Faulty TPS, faulty wiring connections or
10-1-10.
severed line in harness.
Engine was started with neutral warm-up
10-1-11.
lever raised.
(see chapter on Servicing Information
Inspect.
Inspect, repair and replace as necessary.
Inspect.
Inspect and replace as necessary.
Inspect, repair and replace as necessary.
Reconnect at proper installation location.
Inspect, repair and replace as necessary.
Inspect.
Inspect, repair and replace as necessary.
Replace.
Inspect and replace as necessary.
Inspect and repair as necessary.
Inspect and replace as necessary.
Inspect, repair and replace as necessary.
Return lever to normal position and restart.
9-13
Remedy
for specs.)