TOHATSU TLDI 40 Service Manual page 26

Remarks
LT-2 LOR#101 KS-64
O-rings at 2 locations
O-rings at 2 locations
O-rings at 2 locations
O-rings at 2 locations
Air rail, 6 locations
Air rail, 3 locations
O-rings at 2 locations
O-rings at 2 locations
Taper screw
Entire outer surface
Entire outer surface
Apply when inserting pin
Entire outer surface
Entire outer surface
Rollers
Inner and outer area of lip
Rollers
Embedded section (M10PI.O)
Embedded section (M10PI.O)
Both inner and outer surfaces
Both inner and outer surfaces
Both inner and outer surfaces
Both inner and outer surfaces
Apply after cleaning all grease from threading
Lower inner surface
Lip surface
Spline surface
Tapered surface
Spline Surface
Lower inner part
Lip surface
Under-neck surface
Upper surface
b Exterior
a) Pump case, b) Interior
Entire surface
Lightly on inner surface
Apply to one of the mating surfaces
Apply to one of the mating surfaces
Apply to engine side spline
2-13