Phoenix Model CLASSIC - EP Instruction Manual
  1. Manuals
  2. Brands
  3. Phoenix Model Manuals
  4. Toy
  5. CLASSIC-EP
  6. Instruction manual
Phoenix Model CLASSIC - EP Instruction Manual

Phoenix Model CLASSIC - EP Instruction Manual

Hide thumbs Also See for CLASSIC - EP:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual See also: Instruction Manual

Instruction Manual

CLASSIC - EP
Wingspan : 1420mm (55.9 inch)
Length
g
Weight
Engine
Radio
: 1070mm (42.1 inch)
: 1700gr - 2000gr
: AXI motor 2826
: 4 channel / 3 servos standard

Advertisement

Table of Contents
loading

Related Manuals for Phoenix Model CLASSIC - EP

Summary of Contents for Phoenix Model CLASSIC - EP

  • Page 1: Instruction Manual

    Instruction Manual CLASSIC - EP Wingspan : 1420mm (55.9 inch) Length : 1070mm (42.1 inch) Weight : 1700gr - 2000gr Engine : AXI motor 2826 Radio : 4 channel / 3 servos standard...

  • Page 2: Kit Contents

    KIT CONTENTS: We have organized the parts as they come out of the box for better identification during assembly. We recommend that you regroup the parts in the same manner. This will ensure you have all of parts required before you begin assembly KIT CONTENTS elevator control system engine mount...
  • Page 3 Installing the aileron servo and linkage. Installing the aileron servo and linkage. Glue the two hard wood by C.A glue. Mark the shape of the servo box to the Remove the covering. wing. Servo box Hard wood Glue the servo box by C.A glue. Install and secure the aileron servo.

  • Page 4: Installing The Elevator Pushrod

    Mark the shape of the fuselage onto the Mark the shape of the fuselage onto the Remove the covering from the top and top of the horizontal. bottom of the horizontal. the bottom of the horizontal. Glue the horizontal and fuselage by Glue the horizontal and fuselage by Check the horizontal before it dry and epoxy.

  • Page 5: Installing The Rudder Pushrod

    Remove the covering from the slot. Install the clevis to the aileron pushrod. Insert the silicon tube into the clevis. Insert the elevator pushrod into the Attach the clevis to the control horn. Install the elevator servo. fuselage. Cut away the elevator pushrod. Bend "L"...
  • Page 6 Install the metal connector to the servo Install the servor arm into the rudder Cut away the rudder pushrod. arm. servo. Bend "L" the rudder pushrod. Attach the nylon clasp to the servo arm. Installing the landing gear and nose gear. Installing the landing gear and nose gear.
  • Page 7 Installing the engine and cowling. Installing the engine and cowling. Install the engine mount into the fuselage. Glue the engine mount into the fuselage. Glue the three hard wood by epoxy glue. Install the motor. Install the cowl. Install the propller. Installing the Installing the receiver and batter.

  • Page 8: Control Throws

    CONTROL THROWS BALANCING 1. We highly recommend setting up a plane using the 1. It is critical that your airplane be balanced correctly. control throws listed. Improper balance will cause your plane to lose control and crash. 2. The control throws should be measured at the widest THE CENTER OF GRAVITY IS LOCATED 75 - 80mm point of each control surface.

Table of Contents