Tunstall liberty300 Installation Manual page 17

Call back options
1. Press the HELP button to enter the call back unit sub-menu.
2. Press the HELP button to select a programming option, as listed below.
3. To store an option selected, press the CANCEL and HELP buttons together. The
unit will beep three times and display the selected option.
4. Press the CANCEL button to exit the call back unit sub-menu.
Display Programming option
Enabled
Disabled
1. Press the HELP button to enter the call back pendants sub-menu or press the
CANCEL button to scroll to the call back detectors or inputs sub-menus and
repeat steps 1-4 from the call back unit sub-menu.
PABX tones
1. Press the HELP button to enter the PABX tones sub-menu.
2. Press the HELP button to select a programming option, as listed below.
3. To store an option selected, press the CANCEL and HELP buttons together. The
unit will beep three times and display the selected option.
4. Press the CANCEL button to exit the PABX tones sub-menu.
Display Programming option
Enabled
Disabled
Rings detected
1. Press the HELP button to enter the rings detected sub-menu.
2. Press the HELP button to select a programming option, as listed below.
3. To store an option selected, press the CANCEL and HELP buttons together. The
unit will beep three times and display the selected option.
4. Press the CANCEL button to exit the rings detected sub-menu.
Display Programming option
Rings detected
to
Page | 16
Information
Alarm auto-answers an incoming call after an activation
Alarm does not auto-answer an incoming call after an
activation
Information
Alarm will automatically disconnect if it detects a
specific tone (e.g. short beep, long gap)
Alarm will not detect a specific tone so call will
disconnect on time-out or can be manually terminated
by pressing the CANCEL button.
Note: If running on a PABX system, this should always
be set to disabled.
Information
Number of rings to detect before auto-answering after
alarm activation.
www.tunstallhealthcare.com.au