Advertisement
10
Tighen set screw loosened in step 5.
13
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and
Remote Receiver to the same settings. This must
be done so the units will communcate properly. If
you have other fans you can set to control from
one transmitter by setting both receivers the same
as the transmitter . If you have more than one fan
with remote. You can set the dip switches to differ-
ent positiosns to have seperate control.
16
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on the
other side of the outlet box.
© 2011 Monte Carlo Fan Company
11
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on the ball
engages the ridge in the mounting bracket. This
will allow hands-free wiring.
14
Install remote receiver by sliding into opening in
the mounting bracket. Make sure that the dip
switches on the transmitter and the receiver are
set to the same positions.
17
Raise the canopy up and align the
two holes in the canopy with the two
holes in the hanger bracket. Secure
with two screws provided.
4
12
Safety cable installation
Safety Cable
Lag Screw
safety
cable
washer
lock
3" lag
washer
screw
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod modes the safety cable must be installed
into the house structure beams using 3" lag
screws, washers and lock washers provided. Make
sure that when the safety cable is fully extended
the lead wires are longer than the cable and no
stress is placed on the lead wires.
Note:If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In
The Outlet Box.
15
Fan
white
fuses
black
orange
blue
Green
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Orange from fan to Orange from remote
marked Light/up. Blue from fan to blue from
remote marked down light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
marked AC L. Connect all green ground wires
to Ground wire from House.
18
Install 1 x 100 watt JD E-11 halogen bulb. Do
not touch bulb surface as oily residue from skin
can cause the bulb to explode. Bulb included.
WARNING: Over lamping the fan will re-
sult in the fan lights shutting down
until the proper wattage of bulbs are
installed. Reset the lights by turning off
the wall switch, breaker,or by remote. Re-
place bulbs with the correct wattage bulbs,
turn the power on.
House
white
black
3/2/2012
Advertisement
