Table of Contents
Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
8KGR72XXXD Series Fan
CUL Model NO. : 8KGR72
RETAILER NAME:
RETAILER ADDRESS:
13.15 kgs
28.93 lbs
Total fan weight with light
Advertisement
Table of Contents
Related Manuals for Monte Carlo Fan Company 8KGR72 D Series
Summary of Contents for Monte Carlo Fan Company 8KGR72 D Series
- Page 1 Owner’s Guide and Installation Manual 8KGR72XXXD Series Fan CUL Model NO. : 8KGR72 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 13.15 kgs 28.93 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Note: Suitable for use in damp locations. Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety Glasses, Stepladder and Wire Strippers Customer Service 800-969-3347 Customer Service Center 7400 Linder Ave. Skokie, IL 60077 www.montecarlofans.com © 2018 Monte Carlo Fan Company 10/2018... -
Page 3: Safety Cable Installation
3” lag screws, washers and lock washers provided. Note : If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The Outlet Box. © 2018 Monte Carlo Fan Company 10/2018... - Page 4 15º. Warning: Cross pin and keeper pin must than the cable and no stress is placed on be installed securely, failure to install them the lead wires. will result in serious injury. © 2018 Monte Carlo Fan Company 10/2018...
- Page 5 first blade may keep the fan level and make installation easier) grooves in canopy ring with the humps on canopy and snap it onto canopy. Note: Make sure the side with a label “This side up” is installed upward. © 2018 Monte Carlo Fan Company 10/2018...
- Page 6 fixture with the preassembled screws on and twist clockwise until tight. the light pan. Twist clockwise till lock. Reinstall the screw removed in step 17. Tighten all screws securely. © 2018 Monte Carlo Fan Company 10/2018...
-
Page 7: Remote Control Setting And Operation
Setting for both transmitters must be seconds done within 1 minute of restoring power to the fan. A fan can be controlled by 2 transmitters maximum when choose Learning Mode. © 2018 Monte Carlo Fan Company 10/2018... -
Page 8: Light On/Off
5. When fan is turned on or operated forward/reverse function, it shutters & goes back & forth until it turns. It is a normal performance of this fan and it will take for few seconds to run this operation. © 2018 Monte Carlo Fan Company 10/2018... -
Page 9: Troubleshooting
5.Remove light kit and check the plug connections if they are present. 6.If this fan uses remote controller, make sure dip switches are setting properly and make CAUTION: Make sure main power is turned off before entering switch housing and/or canopy. © 2018 Monte Carlo Fan Company 10/2018... - Page 10 Oct.2018...