First Operation; Instruction; Initial Charging Procedure; Before Putting Into Operation - HAKO Sweepmaster P1200 RH Instruction Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before first oper-
ation. First instruction into handling of
the machine must be held by a qualified
person sent by your local Hako contract
dealer. Your Hako dealer will be in-
formed by the manufacturer upon deliv-
ery of the machine and will contact you
to make a date for instruction.
2.2

Initial charging procedure

Before first operation of the
machine, fully charge the bat-
tery with an initial charging pro-
cedure and comply with the op-
erating instructions of the
charger as well as with those of
the battery manufacturer.
Hako cannot be held liable for
damages resulting from an in-
sufficient initial charge.
2.3

Before Putting into Operation

Complete the following inspections be-
fore taking the machine into operation:
1. Check the area around the machine
for signs of leakage. Hoses, lines
16
and tanks must be free from any
leakage or damage.
2. Open seat hood.
3. Check fuel level and refill if required.
4. Check engine oil level.
5. Close seat hood.
2.4

Start Machine

Before starting the machine
you are advised to read and
comply with the Provisions of
Operating from Safety Infor-
mation chapter!
Before starting the machine, subse-
quently ac-tuate the following control el-
ements:
1. Set all operating levers and switches
to neutral.
2. Secure the vehicle by engaging the
parking brake.
3. Turn ignition key to switch on igni-
tion.
4. Sweepmaster P1200 RH:
Actuate choke (with cold engine on-
ly).
Sweepmaster D1200 RH:
Preheat until control lamp extin-
guishes.
5. Continue turning ignition key clock-
wise to start engine.
- After the motor has started, the en-
gine oil pressure and charge status
lamps have to extinguish.
Do not use the Sweepmaster
at ambient temperatures of
more than 40°C.
Do not start the machine at
temperatures of -15°C or less.
Liquid propellant gas system:
refer to LPG operating instruc-
tions.
Its not possible to start the ma-
chine, when the accelerator
pedal is linked.
If the starting procedure has to
be repeated or if the engine
stops, re-starting is possible
only after ignition has been
turned off. The ignition lock is
equipped with a protection to
preclude repeated ignition with
the engine running.
Interruption of the starting pro-
cedure ofter 10 seconds and
brief pause between starting
cycles is recommended to
save the battery.