Operation; Machine Stopping And Parking; After Work - HAKO Sweepmaster P1200 RH Instruction Manual

First Operation
6. Run the engine up and press slowly
the choke knob (Sweepmaster
P1200 RH) down.
Refer to LPG operating instruc-
tions for information on how to
start machine equipped with
liquid propellant gas system.
2.5

Operation

Proceed to the following to set the ma-
chine into operation:
1. Check the machine, see paragraph
2.3 - Before Taking into Operation.
2. Start vehicle, see paragraph 2.4.
3. Adjust service speed.
In initial position, vacuuming is
activated. Use the operating
draw if the collected dirt is wet.
4. Lower sweeper roller and side
broom.
5. Release parking brake.
6. Slowly depress drive pedal until de-
sired speed has been attained.
7. Check filling level of the dirt hopper
and emty if required.
8. Operate shaking installation regular
for cleanig the filter.
2.6 Machine stopping and park-
ing
1. Release drive pedal which returns
automatically in neutral position and
the machine slows down to stand-
still.
2. Actuate parking brake.
3. Lift sweeper roller and side broom.
4. Turn engine off.
Slowing down the Sweepmas-
ter is possible by applying op-
posite forces with the drive
pedal or by using the service
brake.
When leaving the machine un-
attended, pull key in order to
preclude unauthorized use.
2.7

After work

1. Move the machine to suitable site for
cleaning.
2. Stop machine, lift sweeper roller and
side boom.
3. Start shaking procedure.
4. Empty dirt hopper, see operation
chapter 3.2.2.
5. Clean machine.
Do not clean the electrical
parts by means of high-pres-
sure cleaning equipment.
17