Maintenance Instructions - HAKO Sweepmaster P1200 RH Instruction Manual

Safety information
switch must not be bypassed!
• Disengage all drive systems before
cranking the engine.
• The machine may be started, run
and stopped by a person seated on-
ly.
• Never let the engine run in indoor ar-
eas! Intoxication hazard!
• Provide for sufficient ventilation
when sweeping indoors (dust and
combustion gas).
Intoxication hazard!
• Always adapt the driving speed to
the ambient conditions and the load-
ing state.
Compared to four-wheeled vehicles,
driving stability of three-wheeled ve-
hicles is reduced, therefor:
Abrupt steering manoeuvres at high-
er speed or negotiating curves at
high speed may cause tipping of the
articulated vehicle.
Do not turn at slopes but on level
ground only
Ride up- and downhill straight.
Avoid taking sudden curves when
riding up- or downhill or across to the
slope.
In slope there is tilting danger.
• The machine may be used only for
8
operation on areas with a maximum
inclination of up to 18 %.
• Do not exceed the admissible total
weight and the admissible axle load
limits. Check the dirt hopper filling
level frequently.
• Before lifting or lowering the dirt hop-
per make sure that no persons, ani-
mals or other obstacle are in the area
of operation.
• Pinching and shearing hazard.
Provide for required safe distance
before lifting or lowering the dirt hop-
per.
• It's only allowed to lift up the dirt hop-
per in immediately nearness of the
container.
Emtying the dirt hopper on level and
solid floor.
• Do not sweeping when the dirt hop-
per is lifted.
• By emtying the dirt hopper pay atten-
tion to bystanders.
• Proceed to filter shaking only if the
dirt hopper is in closed position.
• Pay attention to hot parts for exam-
ple cooling water, tubes of the ex-
haust etc.
1.4

Maintenance instructions

• The daily and weekly maintenance
and repair task must be performed
by a qualified operator. For any fur-
ther maintenance and repair work
beyond please contact your local
Hako service center.
• Observe the maintenance activities
and intervals set out in the instruc-
tion manual.
• Maintenance and repair work may
be carried out only by means of ap-
propriate tools.
• Have the machine checked for safe
condition in the sense of the Acci-
dent Prevention Regulation by an
expert at regular intervals (recom-
mendation: at least once yearly) as
well as after modifications or repair.
• Spare parts have to equal the techni-
cal requirements as specified by the
manufacturer! Genuine spare parts
guarantee compliance with these re-
quirements.
• Use of other than the sweeper rollers
and side brooms approved by the
manufacturer is not admitted (see
technical data) since use of other
sweeper rollers and side brooms
may affect your safety.
• Use of other than the air- and oilfil-
ters approved by the manufacturer is