Pitney Bowes DA300 Operating Manual page 31

Setting Up A
Job (continued)
1. Set the Separator Gap
H-Block Separator
Lock Knob
Rear Wall
Place a
sample piece
against the
rear wall and
between the
separator
fingers and the
feed roller
Setup Example Using DL Size Envelopes:
When you set the feed gap for a DL size envelope, the width of
the envelope will fall completely under the inside and middle H-
Blocks, but only half way under the outer H-Block.
In this case, place a second envelope next to the first, under the
outer H-Block. Place the second envelope flap down with the
short edge under the outer H-Block. (Before you do this, remove
the sliding fence in order to fit the second envelope under the
outer H-Block). Lock the separator in place.
Basics
3-7