Pitney Bowes DA300 Operating Manual page 29

Setting Up A
Job (continued)
4 3
5
6
7
8
8. Feed Fence
Helps confine the stack. Adjust to the width of your material plus
1.6mm (1/16") clearance.
9. Control Panel
Use the control panel buttons to access printer menus, define
print options, run the print job , position the print carriage and
turn the printer on and off line. See Appendix A, Printer Menus,
for detailed instructions. If you have the DA300 print driver
loaded on your computer, you can easily perform these functions
from within your application.
10. Stacker Tray
Printed material is deposited in the stacker (catch) tray. The tray
holds about 127mm (5") of material.
11. Output Area
Where printed material is stacked.
12. Exit Rollers (Not Shown)
Guides the printed material as it exits the printer. Adjust so that
each roller overlaps the edge of the material by 6.3mm (1/4").
13. Top Cover
Open to gain access to the print cartridge and exit rollers.
2 1
Basics
13 12
11
10
9
3-5