Table of Contents
Advertisement
2
Listing and Approval Codes
A. Appliance Certification
Model:
Adventure III
Laboratory:
Underwriter's Laboratories, Inc.
Report No:
MH 60687
Type:
Solid Fuel Room Heater
Standard:
UL1482-10 and ULC S627-00
and (UM) 84-HUD, Mobile Home
Approved.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S628-93
and CAN/CSA-B365 Installation Codes in Canada.
►
B. BTU & Efficiency Specifications
EPA Certification #: 1001-15
EPA Certified Emissions: 2.9 grams per hour
*LHV Tested Efficiency: 75.5%
**HHV Tested Efficiency: 70%
***EPA BTU Output: 11,200 to 43,300 / hr.
****Peak BTU/Hour Output: 98,100
Vent Size: 6 inches
Firebox Size: 4.5 cubic feet
Recommended Log Length: 22 inches
* Weighted average LHV (Low Heating Value) efficiency using
Douglas Fir dimensional lumber and data collected during EPA
emission test. LHV assumes the moisture is already in a vapor
state so there is no loss in energy to vaporize.
**Weighted average HHV (High Heating Value) efficiency using
Douglas Fir dimensional lumber and data collected during EPA
emission test. HHV includes the energy required to vaporize the
water in the fuel.
***A range of BTU outputs based on EPA Default Efficiency and
the burn rates from the low and high EPA tests, using Douglas
Fir dimensional lumber.
****A peak BTU out of the appliance calculated using the maxi-
mum first hour burn rate from the High EPA Test and the BTU
content of cordwood (8600) times the efficiency.
The Quadra-Fire Adventure-III Series Wood Burning Appli-
ance meets the U.S. Environmental Protection Agency's
crib wood emission limits for wood heaters sold after May
15, 2015.
This appliance needs periodic inspection and repair for
proper operation. It is against federal regulations to oper-
ate this appliance in a manner inconsistent with operating
instructions in this manual.
6
Fuel Seasoned Cord Wood
Quadra-Fire • Adventure-III Owner's Manual • 4083-900 • Rev D • 09/15
C. Manufactured Housing Approved
• This appliance is approved for manufactured hous-
ing installations when not installed in a sleeping
room and when an outside combustion air inlet is
provided.
• The structural integrity of the manufactured housing
floor, ceiling, and walls must be maintained.
• The appliance must be properly grounded to the
frame of the manufactured housing with #8 copper
ground wire, and chimney must be listed to UL103
HT or a listed UL-1777 full length six inch (152mm)
diameter liner must be used.
• Outside Air Kit, part OAK-ADV must be installed in a
manufactured housing installation.
D. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please con-
tact your dealer for replacement glass.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Do NOT Overfire - If appliance or chimney connector glows,
you are overfiring.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifications and/or price without notice.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
Hide quick links:
Advertisement
Table of Contents
