Smart Burn Technology System Activation; Programmable Thermostat - Quadra-Fire Adventure-III Owner's Manual

Smart Burn Technology (SBT)
The Smart Burn Technology system allows the thermo-
stat to be set at the desired temperature, start the fire,
load the appliance with wood and it will burn efficiently
and clean with little interaction by the homeowner.
Battery Backup allows the appliance to operate without
110V but will not operate optional BK-350 fan.
The appliance can be also operated manually if neces-
sary.
1. Smart Burn Technology Activation
Pushing the button will activate the appliance and
open the air control to high.
Green Light
The green light illuminates when the button is pressed.
This is indicating that the appliance is ready for a new
fire or a reload. If neither of these events happens, the
light will stay on for 2 hours and the air control will stay
open. After 2 hours of no heat rise in the appliance
then the light will go out and the air control closes to
the zero position.
If a fire is started or the appliance is reloaded, the light
will stay on through the warm up cycle. If the thermo-
stat is calling for heat then the light stays green for as
long as the appliance is burning on high.
No Light
The appliance will progress into a shutdown phase
and slowly cool down and the light will turn off. Every-
thing is working OK, but the SBT button will need to be
pushed when reloading fuel.
Red Light
When the thermostat calls for heat while the appliance
is in charcoal phase, the air control will open all the way
and the red light illuminates. This is indicating that the
appliance is trying to heat the room but there is only
charcoal left and needs reloaded.
Quadra-Fire • Adventure-III Owner's Manual • 4083-900 • Rev D • 09/15
2. Programmable Wall Thermostat
Battery Installation and Replacement
NOTE: 2 AA batteries are included with the thermostat
and must be installed before the appliance can be oper-
ated.
Press and pull to remove.
Install fresh batteries immediately when the REPLACE
BATTERY warning begins flashing. The warning flash-
es about two months before the batteries are depleted.
Even if the warning does not appear, you should re-
place batteries once a year.
If batteries are inserted within two minutes, the time and
day will not have to be reset. All other settings are per-
manently stored in memory.
11