Operation - Intertek Jotul GF 400 DV Sebago Installation And Operation Instructions Manual

Operation

Familiarize yourself with the controls of the GF 400 DV
Sebago. Make sure that anyone else using the appliance is
also familiar with the controls and operation procedures.
Always follow the Lighting Instructions on the inside back
cover of this manual and also located on the Rating Plate
attached to the back of the stove.
1. Once the pilot is lit, burner operation is controlled by
the rocker switch located at the left rear corner of the
stove. Use the T-STAT position for the optional thermo-
static or remote control functions. See fig. 40.
2. During the first few fires, you may notice odor and/
or smoke from the stove. This is normal and results
from burn-off of manufacturing residue and curing of
materials. You may find it helpful to provide additional
ventilation and fresh air to alleviate this condition.
3. Condensation may occur on the glass upon each light-
ing of the appliance. This "fog" will disappear as the
appliance heats up.
4. Keep the controls and the area under the appliance
free of debris, vacuum this area frequently. Always keep
the appliance area clear and free from combustible
materials, gasoline and other flammable liquids.
If a vacuum is used during any service on the stove,
ALWAYS be sure the stove is cold and there are NO hot
embers.
5. Remember, this appliance has a continuous burning pi-
lot flame. Exercise caution when using products having
combustible vapors. Always shut-off gas supply while
servicing the stove.
6. CAUTION: DO NOT OPERATE THIS APPLIANCE WITH THE
GLASS REMOVED CRACKED OR BROKEN.
Replacement of the glass should be done by a licensed
or qualified service person. Use only replacement glass
provided by your authorized Jøtul dealer. Never use
any substitute materials.
WARNING: OBSERVE CAUTION WITH THE GLASS. THE
GLASS PANEL MAY SHATTER UNEXPECTEDLY IF STRUCK
WITH AN OBJECT. ALWAYS HANDLE THE GLASS PANEL
WITH CARE. WHEN SERVICING THE STOVE ALWAYS
PULL THE GLASS ASSEMBLY STRAIGHT UP FOR REMOV-
AL.
7. Clean the glass only when necessary. Wipe surface
with a clean, damp soft cloth. Follow with a dry, soft
towel as desired. Take care not to scratch the glass
surface.
WARNING: DO NOT USE ABRASIVE CLEANERS ON THE
GLASS. NEVER CLEAN THE GLASS WHEN IT IS HOT.
Figure 40. Burner Switch and Optional Blower Controls
137750_Rev_L 11.16.12
23