Log Set Installation - Intertek Jotul GF 400 DV Sebago Installation And Operation Instructions Manual

Log Set Installation

NOTE: If appropriate, install the optional Antique Brick
Panel Kit before assembling the logset.
The logset must be installed before operating the burner.
The logset includes five log pieces, packaged inside the
firebox, and a quantity of ember stones packaged in the
Miscellaneous Parts bag.
To install the log set, remove the packaging and place the
parts on the locator pins inside the firebox as illustrated
in figs 32-37. Do not handle the log set with your bare
hands. Always wear gloves to prevent skin irritation from
the ceramic fibers.
IMPORTANT
The ember stones realistically simulate glow-
ing coals when the burner is operating.
These should be spread evenly over the burner
plate and around the logs.
TO INSURE PROPER BURNER FUNCTION, DO
NOT OBSTRUCT THE PILOT ASSEMBLY AND BURN-
ER SKIRT OPENINGS WITH EMBER STONES. KEEP
EMBERS AWAY FROM PILOT CARRY-OVER PORTS.
See fig. 37
You do not need to use all of the ember
stones. With some experimentation, you will find
the arrangement and quantity of embers that
works best with your stove. Depending upon the
characteristics of your installation, it is possible
that too many ember stones can promote sooting
on the logs. Adjust the quantity of ember stones
as appropriate to maintain the best overall flame
picture and burner performance.
Figure 32. Install Right Log
220647
Figure 33.
Install Rear Log
Figure 34.
Install Left Log
220646
Figure 35.
Install
Middle Log
220648
Figure 36.
Install
Crossover Log
Figure 37. Install Ember Stones
137750_Rev_L 11.16.12
220645
220701
DO NOT
OBSTRUCT
PILOT
OPENING
21