Vertical Termination - Intertek Jotul GF 400 DV Sebago Installation And Operation Instructions Manual

FRONT
LEG
Fully Closed
Fully Open
Figure 6. Adjusting the Air Inlet Restrictor plate - View is
from the right side of the stove.
Vertical Vent Termination
This appliance can be vertically vented through a ceiling
or to a roof termination with the following guidelines:
The termination should fall within the shaded areas

of the grids depicted in the Vent Window diagrams on
the pages 10-11.
Maximum Vertical run should not exceed 35 ft. (10.66

m).
Minimum Vertical run must be at least 8 ft. (2.43 m).

Max. Colinear Horizontal run is 2 ft. (61 cm).

Vent Terminus Clearance: In no case shall any dis-

charge opening on the cap be less than 18 in. (610 mm)
horizontally from the roof surface.
Steep roofs, nearby trees, and predominantly windy

conditions can contribute to poor draft and/or pro-
mote down-draft occurances. Increasing the height of
the vent may alleviate these conditions.
Use Wall Straps to support an offset pipe run at three

feet intervals to avoid excessive stress on the offsets.
Elbows: Four 45°, or two 90° elbows may be used. Do

not include the 45° elbow attached to the stove. When-
ever possible use 45° elbows instead of 90° elbows as
they are less restrictive to exhaust gas and intake air
flow.
A firestop is required at every floor. The opening

should be framed to 10" X 10" inside dimension.
Any venting that is exposed above the first floor,

regardless of attic space or living space, must be en-
closed. Always maintain the required 1" clearance from
all sides of the vertical vent system.
BACK
LEG
Push the
Pivot Pin into
the slot
Figure 7. Adjusting the Exhaust Restrictor plate - Top Plate
removed. Viewed from front of stove.
Termination
Cap
Figure 8. Vertical vent termination height above roof.
A
B
C
D
Horizontal Overhang
18”.
18”.
min. min.
18” min.
137750_Rev_L 11.16.12
Default
Factory
Setting is
"D"
A
B
C
D
Front of Stove
Lowest Discharge
Opening
9