Table of Contents
Advertisement
Getting Started
Check to see that the hopper is clean and free from foreign materials. Be sure to connect this unit to a working
•
outlet; we recommend using a surge protector to help protect the electronic components from damage.
BEFORE your first fire, dry run your unit (no pellet fuel in the hopper) for twenty minutes; pressing the "ON" button
•
with the unit plugged in will initiate the dry run.
•
When the "ON" button is pressed:
Top Mount control boards: the board will scroll the message "DID YOU CLEAN BURN POT BEFORE
STARTING? HOLD ON TO CONFIRM". Press and hold the "ON" button for 3 seconds to start the unit.
Side Mount boards: After a few seconds, the letters "S U" will appear in the display windows.
Once the unit starts, you should immediately hear the exhaust blower start and operate continuously. The
•
board will display the last setting it was set to for the duration of its operation, or until the setting is
adjusted. (Side Mount control boards will continue to show "S U").
After about three to five minutes, look for the red glow of the igniter in the igniter port of the burn pot to be
•
certain it is operating normally.
•
Hold the hopper lid switch (See "Illustrated Parts Diagram" at rear of this manual) down with your finger and
check to see that the auger is turning. Release the hopper lid switch and be certain that the auger stops
turning. DO NOT PUT YOUR FINGERS IN THE HOPPER OR NEAR THE ROTATING AUGER.
•
Top Mount boards Please Note: If the lid switch is left disengaged (not pressed down) for 60 seconds, the
unit will shut down with an error message of "HOPPER LEFT OPEN. SHUTTING DOWN – if this happens, the
unit must be allowed to shut down and the dry run would then need to be repeated from the beginning.
Note that the front door must be closed for the auger to cycle (the board will not give a vacuum loss error,
•
as the board does not look for this until proof of fire is met, but the auger will not cycle if the door is open).
•
Top Mount boards: After approximately twenty minutes, the control board should display "FAILED TO START
SHUTTING DOWN" several times, and then it will continue to display "FAILED TO START". To clear the error
message simply press the "OFF" button.
Side Mount boards will display "E-2" in the two display windows (more information on Error Codes
can be found in the Error Code section of this manual).
•
At this point, the dry run is complete and your pellet heating appliance is ready for normal operation.
Lighting a Fire
•
In order for this stove to operate, the hopper must first be filled with pellet fuel. Lift the hopper lid and pour the
pellet fuel directly into the hopper. Of course, your stove should be connected to your venting system at this point.
We recommend using only pellets manufactured by PFI Certified facilities, since pellets bearing the PFI
stamp of approval will be low in ash and moisture, high in BTU's, and uniform in size and quality.
This pellet stove will perform equally well using softwood and hardwood pellets, and although the ash may differ
•
slightly in appearance or texture, both types of pellets will burn cleanly and efficiently in this stove.
This pellet stove is equipped with an automatic pellet ignition system. Simply press the "ON" button
•
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
DAILY OPERATION
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
19
Advertisement
Table of Contents
