Mounting Instructions - CDVI Galeo Installation Manual

INSTALLATION MANUAL
GALEO
Illuminated Weatherproof Keypad with remote electronics

4] MOUNTING INSTRUCTIONS

Once you have made sure that the mounting kit is complete and that you prepared
the cables of the GALEO keypad and its remote electronic then you can proceed
and mount the product. Make sure that you have all the appropriate tools
(drill, screw drivers and a meter tape...) and follow the mounting instructions
of the GALEO keypad and of the remote electronic.
1
Verify the distance between the
GALEO keypad and its remote
electronic (refer to page 3 Notes
and Recommendations). Place
the back plate of the GALEO on
the wall and the bracket of the
remote electronic then
with a pen the hole location
then drill the 2 mounting holes
(drill bit Ø 5 mm and
hole depth) and the hole wiring
access.
4
Fasten the GALEO keypad to the
back plate by using the supplied
(M4x10) Torx screw and T20
®
Trox spanner hardware. Place the
screw cap at the bottom of the
keypad.
cdvi.se
4
cdvigroup.com
2
®
GALEO
®
GALEO
Insert the 2 plastic anchors in
the holes. Place the back plate
of the GALEO and screw on the
wall using the supplied (M4x30)
mounting screws.
mark
35 MM
5
Insert the 2 plastic anchors in the
holes. Place the bracket of the
electronic and screw on the wall
using the supplied M4x30 screws.
Slide the box from up to down on
the bracket.
®
GALEO
Insert the cable in the hole
access area of the back plate.
Then mount the keypad on the
back plate, placing first the
top in the hooks and then the
bottom.
Insert the cable in the remote
electronic and wire the cable to
the terminals. Donít forget to ins-
tall the varistor on the lock (refer
to page 3 ´Notes and Recommen-
dations').
3
GALEO
6
(x2)
®
GALEO
®
®
GALEO
(x2)
(x2)