Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION MANUAL
KCIN
Illuminated weatherproof Keypad with Remote Electronics
Mounting recommendations
Mount the keypad on a flat surface to avoid
any vandalism and to insure the best mounting.
3] PACKAGE CONTENTS
Remote
electronic
mounting
plate
Remote
1
electronic
KCIN
-
4] MOUNTING INSTRUCTIONS
make sure that you have all the appropriate tools (drill, screw drivers and a meter tape...)
and follow the mounting instructions of for the KCIN keypad and for the remote electronic.
1
Verify the distance between the KCIN
keypad and its remote electronic
(refer
to
page
3
´Notes
Recommendations). Place the back
plate of the KCIN on the wall and the
bracket of the remote electronic then
mark with a pen the hole location
then drill the 2 mounting holes (drill
bit Ø 5 mm and 35 MM hole depth)
and the hole wiring access.
Wire
Varistor
sealed cap
2
-
-
1
2
Insert the 2 plastic anchors in the
holes. Place the back plate of the
and
KCIN and screw on the wall using
the supplied (M4x30) mounting
screws.
Mount
the
on the wall with the M5x35
DIAX
screws.
®
Back EMF protection
To secure the system from back electromagnetic
fields do not forget to mount the varistor in parallel
on the lock terminal.
Diax
®
screws
Diax
®
(M5x35)
-
-
2
1
KCIN
keypad
Screw
Plastic
anchor
(M4x30)
2
2
2
2
3
cdvigroup.com
EN
Brass
anchor
-
2
11
11
Advertisement
Table of Contents
