Mounting Instructions - CDVI KCIN Installation Manual

INSTALLATION MANUAL
KCIN
Illuminated weatherproof Keypad with Remote Electronics 1, 2 or 3 relays

4] MOUNTING INSTRUCTIONS

Once you have made sure that the mounting kit is complete and that you prepared the cables
of the KCIN keypad and its remote electronic then you can proceed and mount the product.
Make sure that you have all the appropriate tools (drill, screw drivers and a meter tape...)
and follow the mounting instructions of for the KCIN keypad and for the remote electronic.
1
Verify the distance between the
KCIN keypad and its remote
electronic (refer to page 3 ´Notes
and Recommendations). Place the
back plate of the KCIN on the wall
and the bracket of the remote
electronic then mark with a pen
the hole location then drill the 2
mounting holes (drill bit Ø 5 mm
and 35 MM hole depth) and the
hole wiring access.
4
Insert the 2 plastic anchors
in the holes. Then mount the
bracket of the remote electro-
nics with the M4x30 screws.
Slide the box from up to down
on the bracket.
cdvi.se
4 4
cdvigroup.com
2
Insert the 2 plastic anchors
in the holes. Place the back
plate of the KCIN and screw
on the wall using the supplied
(M4x30) mounting screws.
5
Insert the cable in the remote
electronic and wire the cable to
the terminals. Donít forget to
install the varistor on the lock
(refer to page 3 ´Notes and Re-
commendations').
3
Mount the KCIN
on the wall with the M5x35
DIAX screws.
®
keypad