Accessing The Hour Run Meters / Timer Program / Clock Sub-Menus; Start-Up - DeDietrich AWHP 4 MR User Manual

5 Operation
Fig.24 Accessing the User menu
Fig.25 Displaying the parameters of the
User menu
Fig.26 Accessing the Hour Run Meters /
Timer Program / Clock sub-menus
Fig.27 Displaying the parameters of the
Hour Run Meters sub-menu
5.2

Start-up

30 MIV-4
1. Access the menus by pressing the two keys on the right simultane­
ously.
2. Select the User menu by pressing the
flashes.
3. Press
Note
The User menu is available only if the
MW-5000008-1
4. Press the
The parameters available to the User are displayed.
5. Go back to the main display by pressing the
MW-5000040-3
5.1.3 Accessing the Hour Run Meters / Timer Program / Clock
sub-menus
Note
The name of the PCB is displayed. Check that it is actually the
PCB on which the setting must be made.
1. Access the menus by pressing the two keys on the right simultane­
ously.
2. Select the menu by pressing the
es. Confirm the selection by pressing the
Note
The Hour Run Meters / Timer Program / Clock sub-menus can be
accessed only if the
MW-5000044-2
3. Select the menu by pressing the
menu is displayed. Confirm the selection by pressing the
4. Go back to the main display by pressing the
MW-5000045-2
1. Switch on the outdoor unit and the indoor module simultaneously.
2. The heat pump begins its start-up cycle.
If the start-up cycle runs normally, an automatic venting cycle is initi­
ated. Otherwise, an error message is displayed.
to access the User menu.
or key until the desired parameter is displayed.
or
icon flashes.
or
or key until the icon
icon flashes.
key.

key until the icon flash­
key.
key until the desired sub-
key.
key.

7623755 - v02 - 03072015