Heat & Glo ST-HVBI-AUB Owner's Manual page 35

FCC Requirements
WARNING! Risk of Fire! Changes or modifi cations
to this unit not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital de-
vice, pursuant to Part 15 of the FCC Rules and
EN298 for multi-functional control. These limits
are designed to provide reasonable protection
against harmful interference in a residential in-
stallation. This equipment generates, uses, and
can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruc-
tions, may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular in-
stallation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
• Contact the dealer or an experienced radio TV
technician for help.
Changing Temperature Scale
To change the temperature display between Celsius
and Fahrenheit, remove the battery cover from the
back of the remote control and slide the switch to
your desired temperature scale (see Figure 46. The
screen will automatically change the indicators on the
room temperature and set temperature portion.
Figure 46. Temperature Scale
35 Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. Q • 5/15
Installation of Remote Control Housing
CAUTION! Risk of Fire! DO NOT install damaged or
modifi ed components. Warranty will be voided if dam-
aged or modifi ed components are installed.
1. Remove remote control
packaging.
2. Remove battery cover from the back of the remote
by sliding it down and install 3 AAA batteries.
To prevent unintended operation when not using your
fi replace for an extended period of time (summer
months, vacation, trips, etc):
• Remove batteries from remote control.
• Unplug switching adapter and remove back-up
batteries.
3. Secure the remote control housing on a fl at wall
surface using the two screws and wall anchors pro-
vided. See Figure 47.
Figure 47. Mounting Remote Control Housing
4. Place remote control inside housing. See Figure 48.
Figure 48. Remote in Housing
5. Close the housing door. See Figure 49.
components from