Installation / Removal Of Optional Vanity Panel - Heat & Glo ST-HVBI-AUB Owner's Manual

LOG #6 (SRV582-705):
shown.
1.10. Installation / Removal of Optional
Vanity Panel
• Remove packaging from around the vanity panel.
• Remove front from appliance.
• Locate valve mount bracket.
If necessary, loosen wing nut on bracket and rotate
ground wire as shown in Figure 39. Tighten wing nut.
Note hole used for fastening vanity panel.
HOLE FOR ATTACHING HOLE FOR ATTACHING
WING NUT WING NUT VANITY PANEL VANITY PANEL
LOCATION LOCATION
GROUND GROUND
WIRE WIRE
Figure 39 Wing Nut on Bracket
28
6
Position log #6 on top of the groove in log #3 with the forked end resting on the grate assembly as
VANITY VANITY
MOUNT MOUNT
BRACKET BRACKET
Heat & Glo • ST-HVBI-AUB • 2082-980 Rev. Q • 5/15
• Place vanity panel in appliance on right side of component
cavity, and slide left into position as shown in Figure 40.
• Attach with 1/4 in. (6 mm) hex fastener (in manual bag)
until snug.
ATTACH WITH 1/4 IN. (6 MM) HEX FASTENER ATTACH WITH 1/4 IN. (6 MM) HEX FASTENER
Figure 40 Hex Fastener
• Reattach front.
6