Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo 6TRSI-AUD Owner's Manual

14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 9.E.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
DO NOT MODIFY THIS APPLIANCE
E. Installation / Removal of Optional Vanity
Panel
• Remove packaging from around the vanity panel.
• Remove front from appliance.
• Locate valve mount bracket.
If necessary, loosen wing nut on bracket and rotate
ground wire as shown in Figure 14.1. Tighten wing nut.
Note hole used for fastening vanity panel.
HOLE FOR ATTACHING
VANITY PANEL
WING NUT
LOCATION
GROUND
WIRE
Figure 14.1 Wing Nut on Bracket
62
VANITY
MOUNT
BRACKET
Heat & Glo • 6TRSI-AUD, 6TRSILP-AUD • 2078-980 Rev. T • 11/15
• Place vanity panel in appliance on right side of component
cavity, and slide left into position as shown in Figure14.
2.
• Attach with 1/4 in. (6 mm) hex fastener (in manual bag)
until snug.
ATTACH WITH 1/4 IN. (6 MM) HEX FASTENER
Figure 14.2 Hex Fastener
• Reattach front.