Installation Of The Gearmotor; Installing The Rack - quiko Titano QK-T4000 Use And Maintenance Manual

INSTALLATION OF THE GEARMOTOR

Open the removable cover of the gearmotor. Loosen the four screws and remove the case. Remove the nuts
used to fasten the anchoring brackets. Position the gearmotor onto the counterplate.
The gearmotor has to be adjusted:
- Horizontally: along the gearmotor base slot (approx. 20 mm).
- Vertically (if necessary): by means of the 4 level nuts and by inserting the spacers.

INSTALLING THE RACK

The rack should preferably be welded to a 40x40 mm channel and then fastened to the gate with M10 bolts and nuts.
Release the gearmotor and set the gate in the open position. Place the rack on pinion and move the gate manually to
secure the rack along its full length. Once the rack has been secured, vertically adjust the geared motor so as to have a
gap of 2 to 3 mm between the pinion and the rack with screws. Firmly secure the gearmotor with the nuts. Slightly
lubricate the rack and pinion after assembly. Manually check that the gate slides evenly.
Fig. 3
Fig. 4