Advertisement
1.
GENERAL OUTLINE
Electromechanical operator designed to automate residential-type gates.
The operator keeps the gate blocked on closing and on opening, without
needing an electric lock. The operator has no mechanical clutch. It must be
controlled by an electronic
end-of-stroke operation is managed by the control
2.
INSTALLATION
Preliminary checks
Check that:
• The gate structure is sufficiently sturdy.
• Also make sure that the actuator pushes against the leaf reinforced
section.
• The leaves move manually and without effort all along their stroke.
• The door stop plates are fitted at the end of both closing and opening
strokes.
• If the gate has not been recently installed, check the wear condition of
all components.
• Repair or replace faulty or worn parts.
Power supply cable
The board power supply cable must be of the H 05 RN-F type or equivalent.
The equivalent cable must guarantee:
- permanent outside use
- rated voltage of 24 V / 230 V
- maximum temperature on the cable surface of +50° C
- minimum temperature of -25° C
Moreover, it must have a minimum section of 3 x 1.5 mm2 and, for the
cable to hold correctly, it must be provided with an external sheath of Ø =
7.1 to 9.6 mm.
M1= operation 1
M2= operation 2
T= earthing
N = common
WARNING! When the power supply cable is damaged, it must be
replaced by the manufacturer or its technical assistance service, or
else by a person having similar qualification, in order to prevent any
risk.
control panel provided with torque setting. The
www.quikoitaly.com
panel.
Advertisement
