Heated Seats Switches (If Fitted) - Triumph Tiger XR Owner's Handbook Manual

Heated Seats Switches (If Fitted)

The heated seats switches (if fitted) are
located on the right hand handlebar,
next to the right handlebar switch
housing.
The heated seats will only heat when
the engine is running.
The upper switch controls the heat level
of the rider's seat with the lower switch
controlling the passenger's seat.
The system is designed to offer a
variable level of heat at the seats from
warm to hot.
The outer ring of the switch will
illuminate as follows for each heat
setting:
• OFF - not illuminated
• HOT - red
• WARM - amber.
1
2
1. Rider's heated seat switch
2. Passenger's heated seat switch
For maximum benefit in cold conditions,
from the OFF position press the switch
once for hot (red) initially and then
reduce the heat level by pressing the
switch again for warm (amber) when the
seat has warmed up.
To turn either of the heated seats off,
press and release the required switch
until it is not illuminated.
Low Power Voltage Cut Off
When the detected voltage is lower than
11.8 volts continually for more than five
minutes the LED in the heated seats
switches will flash five times. After the
fifth flash the main switch will power off
the heated seats and the LED indicator.
The main switch will not power back on
automatically even if the voltage rises to
the safe level.
The user must manually press the
switches again to activate the heated
seats.
If the detected voltage is still lower than
11.8 volts, the LED for the switches will
flash five times again and cut off the
power automatically.
Fuse number four of the front fuse box
protects the heated seats circuit, refer
to the label in the fuse box lid for fuse
RES /+
amperage.
SET /-
General Information
63