Installing The Rear Wheel - KTM 690 Duke Owner's Manual

13 WHEELS, TIRES
13.4

Installing the rear wheel

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
Main work
–
Check the rear hub rubber dampers.
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Remove bushing
shaft seal rings.
Long-life grease (
–
Install the bushing.
–
Clean and grease the thread of the wheel spindle and nut.
602566-10
Long-life grease (
–
Clean the fixing locations on the brake caliper support and swingarm.
( p. 110)

. Clean and grease the mating surfaces of the bushings and the
p. 183)
p. 183)
108