Buell 2004 XB9S Service Manual page 480

HOME
6250
9
8
7
1. Tool handle
2. Washer
3. Bearing
4. Bridge
5. Forcing screw
6. Diaphragm spring
7. Snap ring
8. Pressure plate
9. Spring seat
Figure 6-19. Pressure Plate Assembly
8815
3
1. Adjusting screw assembly
2. Retaining ring
3. Tab recesses
Figure 6-20. Clutch Adjusting Screw Assembly and
Retaining Ring
7. Install primary cover. See
8. Adjust Clutch. See
9. Fill with SPORT-TRANS FLUID. See
1
2
Always connect positive battery cable first. If the positive
3
cable should contact ground with the negative cable
installed, the resulting sparks may cause a battery explo-
4
sion which could result in death or serious injury.
10. Connect negative battery cable to battery terminal.
5
Tighten fastener to 60-96 in-lbs (6.8-10.9 Nm).
6
Pull up on seat to verify that it is properly secured, front
and rear. A loose seat may shift during vehicle operation
and startle the rider, possibly causing loss of vehicle
control resulting in death or serious injury.
11. Install seat. See
2
1
6.2 PRIMARY
1.9 CLUTCH.
11 1
WARNING WARNING
11 1
WARNING WARNING
2.41 SEAT.
2004 Buell Lightning: Drive/Transmission
COVER.
1.9 CLUTCH.
6-15