Disconnection And Removal - Buell 2004 XB9S Service Manual

HOME

DISCONNECTION AND REMOVAL

1. Remove seat. See 2.41
1 1
WARNING WARNING
To protect against accidental start-up of vehicle, discon-
nect the negative battery cable before proceeding. Inade-
quate safety precautions could result in death or serious
injury.
1 1
WARNING WARNING
Always disconnect the negative battery cable first. If the
positive battery cable should contact ground with the
negative cable installed, the resulting sparks may cause
a battery explosion which could result in death or seri-
ous injury.
2. Unthread fastener and remove battery negative cable
(black) from battery negative (-) terminal.
3. Unthread fastener and remove battery positive cable
(red) from battery positive (+) terminal.
4. Unhook battery strap from frame.
5. Remove battery.
SEAT.
CLEANING AND INSPECTION
1. Battery top must be clean and dry. Dirt and electrolyte on
top of the battery can cause battery to self-discharge.
Clean battery top with a solution of baking soda (sodium
bicarbonate) and water (5 teaspoons baking soda per
quart or liter of water). When the solution stops bubbling,
rinse off the battery with clean water.
2. Clean cable connectors and battery terminals using a
wire brush or sandpaper. Remove any oxidation.
3. Inspect the battery screws and cables for breakage,
loose connections and corrosion. Clean clamps.
4. Check the battery posts for melting or damage caused
by overtightening.
5. Inspect the battery for discoloration, raised top or a
warped or distorted case, which might indicate that the
battery has been frozen, overheated or overcharged.
6. Inspect the battery case for cracks or leaks.
2004 Buell Lightning: Electrical 7-37