Note On/Off; Prog Chg (Program Change); Lowprog And Highprog - Novation ReMOTE SL Compact User Manual

DeviceID: This sets the Device ID number transmitted in the MMC command message (range 0-127).

NOTE ON/OFF

Control Note
NOTE C-2
BtnType
STEP Upper
The Ports, MidiChan, and Name settings are the same as for Control Change (CC) so see that section for information on
these settings.
Note: This sets the MIDI note value (range C-2 to G8). The Note setting will be displayed as a MIDI note value by default
but you can toggle the display format between note value, decimal and hexadecimal by pressing and holding MENU and then
pressing the ENCODER GROUP B SWITCH. The note value can be set using the buttons and encoder in line with the Note
setting or by pressing a key on the keyboard. To enable keyboard entry of the note value, edit the note value using one of
the buttons or the encoder in line with the setting. A flashing cursor will then appear by the note value to indicate that you
can edit it using the keyboard.
Velocity: This sets the velocity value sent with the note on message (range 0-127).
BtnType (Button Type): This is exactly as described for Control Change (CC) however the STEP option is not available. If
this is set to MOMENTRY then the button will send a note on message when pressed and a note off message when
released. If this is set to TOGGLE then alternate presses of the button will send note on and off messages.

PROG CHG (PROGRAM CHANGE)

CONTROL Low Prog
PROG CHG 0
BtnType
STEP Upper
The Ports, MidiChan, BtnType and Name settings are the same as for Control Change (CC) so see that section for
information on these settings.
LowProg and HighProg: These are like the Low Value and High Value settings but instead they define the Low and High
Program Change number. They should be set in conjunction with the BtnType setting as described in the Control Change
(CC) section. This way you can use a button to select a single program/patch, toggle between two different
programs/patches or step through a whole bank of programs/patches on repeated presses. Note that the VELOCITY
Velocity Ports
127 ComnPORT
Change Case Numbers etc
Lower Punctu
High Prog PORTS
| 1 27 ComnPORT
Change Case Numbers etc
Lower Punctu
MidiChan
ComnCHAN
Name:
« CHAR
MIDICHAN
ComnCHAN
Name:
« CHAR
PAGE 1
PAGE 2
»
PAGE 1
PAGE 2
»
54