Novation ReMOTE SL Compact User Manual page 30

The encoders and buttons only control the 8 mixer tracks active on the SL Compact. To bank to other tracks on the mixer,
use the PAGE UP/DOWN buttons. When the ENCODERS GROUP D SWITCH is pressed, the SL Compact display shows
the function of each of the other group switches, which is useful if you forget how the mixer parameters are assigned to
the SL Compact.
To control sends, the SL Compact must be put into Flip mode. To do this, press and hold the SHIFT button (also labelled
DRUMPADS) then press F1/ENCODERS. In Flip mode, the same controls for the mixer work for the sends on each track,
as follows:
In Flip mode, the SPEED DIAL is used to cycle through send banks. To exit Flip mode, press and hold the SHIFT button then
press F1 once again.
It is possible to control plug-ins from the Pro Tools Automap Template by pressing the BUTTONS GROUP B4 SWITCH to
enter Insert mode. The SL Compact controls can then be used to control plug-ins as follows:
Choose an Insert for control in Insert Select mode
There are in fact two modes for controlling plug-ins – Insert Select mode and Insert Edit mode. You can switch between
these two modes using BUTTON 5. In Insert Select mode you can select different plug-ins and in Insert Edit mode you can
edit plug-in parameters. When you first press the BUTTONS GROUP B4 SWITCH the SL Compact will go into Insert Select
mode but after that it will remember which Insert mode you were previously in when switching between controlling the mixer
and inserts.
Control send panning A/B and faders
Panning Panning Faders
A B
Scroll through plug-ins when assigning Inserts
or adjust parameters in Insert Edit mode
Press any of these to exit Insert mode
Control send mutes
Mutes
Scroll through pages of parameters
in Insert Edit mode
Press with SHIFT held
down to return to
normal mixer mode
Bank to other
mixer tracks
Toggle Insert Select and
Insert Edit modes
Hold down and press
an assignable button
to select a track to
edit in Insert mode
In Insert Select mode,
press to assign a plug-
in to an Insert slot
using the encoder
above. Pressing again
exits Assign mode.
Bank to other mixer tracks
when F1/ENCODERS is held
down to select a different track
30