Mitel Headset Operation (With Or Without Feature Control Switch) - Mitel Navigator 3300 ICP User Manual

Navigator User Guide
To answer calls using your PC headset:
1. Press the flashing line key.
2. Begin speaking when the called party answers. Your PC headset microphone and earphones
transmit and receive audio.
To hang up while using your PC headset:
•
Press (CANCEL).
To Mute your PC headset, do one of the following:
•
Press (MUTE). The
•
Press and hold the PC headset mute feature switch (if available).
To turn Mute off and return to the conversation, do one of the following:
•
Press the lit (MUTE) key. The
•
Release the PC headset mute feature switch (if available).
To disable PC headset operation while on a PC headset call:
1. Disconnect your PC headset.
2. Continue speaking in Handsfree operation. The Handsfree microphone and Handsfree
speaker transmit and receive audio.
3. Lift the handset if you wish to continue the call in handset mode.
To return to PC headset operation from Handsfree or handset operation:
4. Connect your PC headset.
5. Hang up the handset (if you were on a handset call).

Mitel Headset Operation (with or without Feature Control Switch)

IMPORTANT NOTE: Mitel-approved headsets (with or without a Feature Control Switch)
must be installed in the dedicated headset jack (the jack on the back of the phone).
Installation of a Mitel headset will disable your handset microphone. Disconnecting the
headset at the jack or at the quick-disconnect plug restores handset operation. If handset
operation is required for an extended period of time, you should press the Headset feature
key to return the phone to handset mode.
To enable Mitel Headset operation:
•
Press the Headset feature key.
22
key light turns ON.
key light turns OFF.