Warranty Conditions - Nilfisk-Advance C 100.6 User Manual

EN
Symptom
DA Machine stops
NO
SV
Fuse blows
FI
DE
Machine pulsating
FR
NL
IT
Machine often starts
and stops by itself
ES
Machine starts, but no
water comes out
PT
EL
TR
In case problems other than the above occur, please contact your local Nilfi sk distributor. Local Nilfi sk distri-
butors are listed on the back cover of this instruction.
CS
Customer Service at Penrith – 01768 868995
HU

8 Warranty Conditions

PL
Nilfi sk guarantees high pressure washers for domestic use for 2 years. If your high pressure washer or ac-
ces so ries are handed in for repair, a copy of the receipt must be enclosed.
Guarantee repairs are being made on the following con dit ions:
HR
SL
SK
LV
LT
Repairs under this guarantee include replacement of defective parts, exclusive of packing and postage/car-
riage. Besides, we refer to your national law of sale.
ET
The machine should be forwarded to one of the service centres of the Nilfi sk organisation with description/
spe ci fi ca ti on of the fault.
RU
Repairs not covered by the guarantee conditions will be invoiced. (I.e. malfunctions due to Causes men ti-
o ned in section Troubleshooting Chart of the instruction manual).
ZH
14
Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Fuse too small
Air in inlet hose/pump
Inadequate supply of mains
water
Nozzle partially blocke
Water fi lter blocked
Hose kinked
Pump/spray handle is leaking
Pump/hoses or accessory
frozen
No water supply
Water fi lter blocked
Nozzle blocked
• that defects are attributable to fl aws or defects in materials or workmanship. (wear and tear
as well as misuse are not covered by the gu a ran tee).
• that the directions of this instruction manual have been thoroughly observed.
• that repair has not been carried out or attempted by other than Nilfi sk-trained service staff.
• that only original accessories have been applied.
• that the product has not been exposed to abuse such as knocks, bumps or frost.
• that only water without any impurities has been used.
• that the high pressure washer has not been used for rental nor used com mer cial ly in any
other way.
Cause
Replace fuse. Switch off other machines.
Check that the mains voltage corresponds
to specifi cation on the model tag.
Leave the washer for 5 minutes to cool
down.
Clean the nozzle (see section 6.2)
Change to an installation higher than the
amp. consumption of the machine.
You may try without the extension cable.
Allow machine to run with open trigger until
regular working pressure resumes.
Check that the water supply corresponds to
specifi cations required (see model tag)
NB! Avoid using long, thin hoses (min. 1/2")
Clean the nozzle (see section 6.2)
Clean the fi lter (see section 6.1)
Straighten out hose.
Contact your nearest Nilfi sk Service Centre.
Wait for pump/hoses or accessory to thaw.
Connect inlet water.
Clean the fi lter (see section 6.1)
Clean the nozzle (see section 6.2)
Recommended action
Original Instructions