Electric Lift Switch; Steel Loadbed; Manual Lift Bed Operation; Electric Lift Bed Operation - Ezgo MPT 800 2004 Owner's Manual And Service Manual

Read all of manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings

ELECTRIC LIFT SWITCH

The optional electric lift switch is located on the seat
panel (Ref. Fig. 15 on page 7). See 'Electric Lift Bed
Operation' for operating information.

STEEL LOADBED

!
low the Danger label affixed to the front of the
loadbed.
The manual lift bed is the standard bed for the vehicle.
The bed may be equipped with an optional electric lift
switch.
A loadbed warning label is affixed to the front of the bed.
See Appendix A. For safe operation of the vehicle, this
label must be understood. See the loadbed warning label
for maximum load. The load must be positioned in the
bed as far forward as possible, distributed in such a way
that its center of gravity must not be higher than height
noted on label, and secured. Failure to follow these
instructions may result in severe injury, damage the vehi-
cle and/or cause the vehicle to tip over. Use extra care
when operating loaded vehicle.
Do not permit any one to ride in the bed.
Do not drive the vehicle with the loadbed raised or with
the tailgate unsupported.
When using the electric lift, be sure to avoid backing up
to the edge of a drop off, such as a loading dock or
ravine. A misjudgment of distance or an unstable surface
could result in the vehicle falling backwards.
Before operating loadbed, check to ensure no one is
behind the vehicle.
!
gasoline vapor and cause an explosion.
Always place a gas can on the ground before filling.
Never fill a gas can in the bed of the vehicle. Static elec-
tricity is built up during the fueling process and could dis-
charge causing the gasoline vapor to ignite.

MANUAL LIFT BED OPERATION

!
To reduce the possibility
!
of severe injury or death,
read, understand and fol-
Never fill a gas can in the
!
bed of a vehicle. Static
discharge could ignite
Exercise caution while
!
operating the manual lift.
Ensure the bed prop is in
Owner's Manual and Service Guide
O P E R A T I O N A N D S E R V I C E I N F O R M A T I O N
one of the slots before releasing. Severe injury could
result if bed is released and traps fingers or other
body parts.
To lift the manual lift bed, pull back on the latch release
handle immediately behind the driver seat (Ref. Fig. 10
on page 5). Raise the bed using the handle on the side of
the bed.
Ref Mbl 1
Lift loadbed to a secure position and check stability
before releasing bed handle (Ref. Fig. 11 on page 5).
Ref Bpr 1

ELECTRIC LIFT BED OPERATION

!
not snagged during lifting or lowering procedure.
Severe injury could result if bed is lowered and traps
fingers or other body parts.
The electric lift toggle switch is located on the driver's
side of the front seat panel (Ref. Fig. 12 on page 6).
Move the toggle switch upward to raise the dump bed
and downward to lower the dump bed.
Fig. 10 Manual Bed Latch
Fig. 11 Bed Prop Rod
Exercise caution while
!
operating the electric lift
bed to ensure clothing is
Page 5