Hayward TriStar SP3215VS Owner's Manual
Hayward TriStar SP3215VS Owner's Manual

Hayward TriStar SP3215VS Owner's Manual

3200 series self-priming variable speed pump
Hide thumbs Also See for TriStar SP3215VS:

Advertisement

3200 SERIES SELF-PRIMING
®
TriStar VS
Owner's Manual
Model - SP3215VS
TriStar Variable Speed Pump
The Hayward TriStar Variable Speed Pump is specifically engineered for the demanding
requirements of today's in-ground swimming pool/spa that is equiped with large capacity
filters, heaters, and pool cleaning equipment. The variable speed, totaly enclosed
permanment magnet motor, combined with its advanced hydraulic design, optimizes the
three essiential pump elements to deliver superior flow, energy efficiency, and quietness.
NOTE: To prevent potential injury and to avoid unnecessary service calls,
read this manual carefully and completely.
SAVE THIS INSTRUCTION MANUAL
Hayward Pool Products (Australia) Pty Ltd.
Melbourne-Sydney-Brisbane-Perth
Email: sales@hayward-pool.com.au Website: www.hayward-pool.com.au
P.O Box 4384, Dandenong South, VIC. 3164
ABN 66 083 413 414
Sales Ph 1300POOLS1 Fx 1300POOLS2
30-LITINSB004 Rev-B

Advertisement

Table of Contents
loading

Summary of Contents for Hayward TriStar SP3215VS

  • Page 1 Model - SP3215VS TriStar Variable Speed Pump The Hayward TriStar Variable Speed Pump is specifically engineered for the demanding requirements of today’s in-ground swimming pool/spa that is equiped with large capacity filters, heaters, and pool cleaning equipment. The variable speed, totaly enclosed permanment magnet motor, combined with its advanced hydraulic design, optimizes the three essiential pump elements to deliver superior flow, energy efficiency, and quietness.
  • Page 2: Important Safety Instructions

    All electrical wiring MUST be performed by a qualified electrical contractor, and must conform to local electrical regulations and AS/NZS 3000 Wiring Rules. Use of non-Hayward replacement parts voids warranty. ATTENTION INSTALLER – THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION, OPERATION, AND SAFE USE OF THIS PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS PRODUCT.
  • Page 3 - In addition to installing two or more suction outlets per pump, follow all national, state and local codes applicable. - Installation of a vacuum release or vent system, which relieves entrapping suction, is recommended. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump...
  • Page 4: Product Dimensions

    Introduction This manual contains information for the proper installation and operation of the Hayward TriStar Variable Speed Pump. The instructions in this manual MUST be followed precisely. Failure to install according to defined instructions will void warranty. Product Dimensions *Note: All dimensions in millimetres...
  • Page 5: Electrical Specifications

    Note - If the pump is being installed using the standard Hayward Universal Union that is supplied with the pump then there is no need to apply any type of thread sealant. The union gasket supplied is suffice to seal.
  • Page 6: User Interface Overview

    Note: Scroll through a - g using DISP/FUNC button and adjust each parameter using the arrow buttons. ▲ ▼ Holding the arrow buttons down will enable fast scrolling of the values. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump Page 6 30-LITINSB004 Rev-B...
  • Page 7: Initial Startup

    V3 displaying real being used is displayed remaining for that speed screen showing rpm. time rpm. in Watts (±10%). is displayed. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump Page 7 30-LITINSB004 Rev-B...
  • Page 8: Configuration Menu

    The new speed is only saved by pressing simultaneously the ▲ arrow buttons and then the LED for that speed ▼ will illuminate solid. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump Page 8 30-LITINSB004 Rev-B...
  • Page 9: Start-Up And Operation

    • Have a professional perform this test. • Ensure all Hayward pump and system components are removed from the system prior to performing the test. WARNING All suction and discharge valves MUST be OPEN, as well as the filter air relief valve (if available) on filter, when starting the circulating pump system.
  • Page 10: Maintenance

    • Keep the motor clean. Ensure the air vents and fan are free from obstruction to avoid damage. Do NOT use water to hose off the motor. • Occasionaly, shaft seals must be replaced due to wear or damage. Replace with genuine Hayward seal assembly kit.
  • Page 11: Shaft Seal Change Instructions

    • Disconnect the pump motor power cord from the power outlet before beginning the shaft seal replacement. • Only qualified personnel should attempt to replace the shaft seal. Contact your local authorized Hayward Dealer or service center if you have any questions.
  • Page 12: Parts Diagram

    Adaptor - Motor Support - use on SPX3200GA in Australia - Not Shown SPX0327 “Jack’s formular 327 Multilube” Silicone lube for O-Rings - 1 ounce (28gram) tube USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 30-LITINSB004 Rev-B TriStar Variable Speed Pump Page 12...
  • Page 13: Noisy Pump

    4. Refer to an Authorised Service Agent or another qualified professional. Motor Cuts Out Your Hayward pump motor is equiped with Automatic Thermal Overload Protection. The motor will automaticly shut-off before heat damage buildup can occur due to abnormal operating conditions. The motor will auto-restart when a safe heat level is reached.
  • Page 14: Service Mode

    In this mode only the RPM of the motor can be changed between 600 rpm and 3000rpm and no speeds will be saved in this mode. To exit Service Mode simply cycle the power to the pump on and off. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump 30-LITINSB004 Rev-B...
  • Page 15 3000 RPM Hayward TriStar SP3215VS Pump 2400 RPM 1250 RPM Flow L/min Performance curves for Hayward TriStar VS SP3215VS pump. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS TriStar Variable Speed Pump 30-LITINSB004 Rev-B 30-LITINSB004 Rev-B Page 15...
  • Page 16 Hayward Pool Products (Australia) Pty Ltd. Melbourne-Sydney-Brisbane-Perth Email: sales@hayward-pool.com.au Website: www.hayward-pool.com.au P.O Box 4384, Dandenong South, VIC. 3164 Hayward and TriStar are registered ABN 66 083 413 414 trademarks of Hayward Industries, Inc. 30-LITINSB004 Rev-B © 2014 Hayward Industries, Inc.

Table of Contents