Table of Contents
Advertisement
. To connect the camera to your computer and save files
1.
Turn off the camera and then
use the micro USB cable that
comes with the camera to
connect it to your Macintosh.
• For details about connecting to
the camera and precautions
when connecting, see page 25.
2.
Press [ON/OFF] (Power) to turn on the camera.
When you turn on the camera, check to make sure that the color of its back lamp
changes from red to green or amber (page 26). Note that in this case the camera's
lens will not extend and the monitor screen will remain blank.
In this mode, your Macintosh recognizes the memory card loaded in the camera (or
the camera's built-in memory if it does not have a memory card loaded) as a drive.
The appearance of the drive icon depends on the Mac OS version you are using.
• The first time you connect the camera to your Macintosh with the USB cable,
an error message may appear on your computer. If this happens, disconnect
and then reconnect the USB cable.
3.
Double-click the camera's drive icon.
4.
Drag the "DCIM" folder to the folder to which you want to copy it.
5.
After the copy operation is complete, drag the drive icon to Trash.
6.
Disconnect the camera from the computer.
After confirming that the back lamp is not flashing red, disconnect the USB cable.
Micro USB cable
(included with camera)
186
USB port
USB
Using the Camera with a Computer
Advertisement
Table of Contents
